Surface plaster

Brick walls, erected by a neat and qualified mason, for the most part do not need any additional decoration. The even rows of brickwork are a good background to identify other details of the construction: framing windows and doors, cornice, basement. The outer surfaces of the walls are laid out with ceramic (red) or silicate (white) bricks. It is also possible to build* masonry with the simultaneous use of both types of bricks, when the entire plane of the wall is made in one color, and the other is distinguished by window platbands, decorative inserts in the piers, frizes under the ovation of the roof, etc. Starting to stone work, choose a masonry system, or, more precisely, bandits of facial bricks. It is also important to choose a method of processing seams between bricks, since it is the seams that create a masonry pattern, and the appearance of the entire facade depends on how expressive they are how expressive they are expressive. Brick walls are sometimes faced with sawn or “torn” natural stone, ceramic tiles and other tile materials (lack of high cost). The finishing of the plaster of the external walls is used quite widely this type of decorative processing is relatively economical, simple and based on the use of available materials. The plaster protects the walls well from atmospheric influences (rain, snow, wind) and, most importantly, allows you to give the outer plane of the wall the most different view, color and texture. The plaster of the outer surfaces is produced in three layers – spray, primer and cover. In order for the finishing layer to have the necessary strength, certain requirements must be observed: – spray is made with a layer of at least 3 mm thick; – to reduce shrinkage cracks, the soil is applied in several techniques in thin layers; Each subsequent layer is applied only after hardening the previous one; – for better adhesion of the upper covering layer, the surface of the soil, to increase roughness, scratch. it is a metal (nail) brush; – with a thickness of the outline of more than 40 mm, plaster should be done on a metal mesh (rabitsa grid); – the thickness of the upper covering layer, depending on the nature of the surface processing and the size of the grains of textured filler, take from 3 to 10 mm.