If you cannot carry out hidden wiring, then try to conduct external wiring or the so -called “open wiring” or “open -type wiring”.
The open -type wiring differs in that with this method, wires and cables pass through special brackets and cartridges, directly on the ceiling coating, and walls. Safe installation of electrical wiring using special tubes made of plastic, fiberglass or skirting boards.
All branch and connecting boxes for wiring must be attached to plywood or wooden planks. Their attachment occurs using heat -resistant dowels, screws or due to moisture -resistant glue. Perhaps the absence of connecting boxes. Thus, all connecting places will hold on by tension of wires.
Before installing the wiring on the outer surface of the walls and ceiling, the cables should be cut off and measured. Then straighten along the entire length and attach to the possible installation site on the wall and ceiling, so you try on and understand where it is safer to place the wires of the electrical wiring.
We draw a line on which the communications of the mains will be located.
In those places where two wires intersect with each other, the space between them is preferably rewinding with an insulating tape to increase the level of safety, but the ideal option is the wires inside plastic pipes. Against the background of the white ceiling, they are almost invisible and safer than simple fastening with brackets.
Where the wires of the mains are bent, then the base of the wire must be cut off along. The incision should be at least 7 centimeters long. This is usually done using a sharp knife or scissors.
In the branch boxes, the ends of the wires are freed from the insulation tape. Since these wires are mainly for switches and outlets, do not forget to leave a wire supply with a length of at least 7 cm. Thanks to this, you can conveniently install sockets and switches, and subsequently, you can replace them.
When installing bare wires of connecting and branch boxes, do not allow zero and phase to contact. Do not spare the insulation tape and firmly strengthen the wires separately from each other.
